rx5808-pro-diversity
#DIY Advanced - Custom Board This requires ordering a board from https://oshpark.com/shared_projects/7J17i6at No bootloader is nessissary with this board. Program the board using the SPI breakout pins. (Select Arduino Pro Mini 5v 328 as the board)
####BOM
- 4x 1K ohm resistor 0805 Mouser
- 1x 470 ohm resistor 0805 Mouser
- 3x 330 ohm resistor 0805 Mouser
- 2x 100k ohm resistor 0805 Mouser
- 2x 22pf capacitor 0805 Mouser
- 1x 16.0000mhz crystal Mouser
- 2x rx5808 receiver with spi mod
- 2x Blue LEDs 0805 Mouser
- 1x Red LED 0805 Mouser
- 1x Navigation switch or ebay
- 2x SMA Connector Mouser
- 1x 4066D SO14 digital switch chip SMD Mouser
- 1x MEGA 328P TQFP Mouser
- 1x Active Buzzer (Optional)
- 1x OLED 128x64 display I2C (5v tollerant) (Optional - If you don’t want to do TV_Out)
Mouser cart with everything but rx5808, navigation switch and optional parts.
####Schematic
####Board
Silk:
Top:
Bottom:
####Example Below is an example of the board installed into a 7” monitor. This board will also fit into a 5” monitor. There are two outputs one for the currently active rx5808 module. The other is the GUI that from the ATMEGA 328 chip.
This monitor has two inputs and a source button on the front for switching between the video signals. If your monitor does not allow for two inputs you can use a toggle switch to acheive the same result.
